Clamp for vertical use. Photo and video shooting perinski

https://www.thingiverse.com/thing:3084138
The clamp is suitable for use by small cameras like Hero or Yi 4k + and other similar ones. You can also use smartphones for shooting.The clamp can be mounted on the shelf or edge of the table. Using the ball head - the viewing angle is not limited. Also suitable for other devices for installing cameras.I used tubes with a diameter of 8 mm, a wall thickness of 1 mm. Anodized aluminum. Threaded stud - M5 length 110 mm. Rubber substrate can be printed with soft filaments.Some parts have to be glued together, but I'm sure you can do it :) In principle, it was possible to make clamps and thinner, but I was reinsured and made a margin of safety. In the video, I showed the stages of assembly of some parts.

Go to the video ->

For the options of suitable ball heads, see below.

• Mini Ball Head - http://ali.pub/2z2lot

• Ball Head v1 - http://ali.pub/2z2lt3

• Ball Head v2 - http://ali.pub/2z2m0h
• Ball Head v3 - http://ali.pub/2z2m37
• Ball Head v4 -http://ali.pub/2z2m6b

• Donate with PayPal
  
• Buy & save with cashback
  

Instagram Twitter Pinterest Tingiverse