Tape dispenser cutter 50mm - V2.5 _Stefano17_
Hello, after several projects, I found a compromise, which is valid for two uses.
It is possible to use the kit with or without cutter, depending on
your needs.
It is possible to use the two supports at will, only one
of the two or both coupled together.
The tolerances of the joints
are 0.2mm
The press was made in ABS, it is a while that I use it and I have
not seen signs of failure, if there were any problems I remain
available.
The project was designed for 50mm thick tape
Video Clip: https://www.youtube.com/watch?v=3EMWPnoFX6Q
| Price | $0.99 |
| Category | Other |
| Purchases | 3 |
| Views | 1964 |
| Likes | 1 |
| Uploaded | 05/17/2018 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
| Cutter V2.5.stl | 10 KB |
| Dispenser Nastro V2.5.stl | 58 KB |
| Supporto1 V2.5.stl | 91 KB |
| Supporto2 V2.5.stl | 43 KB |
Note: if you want to re-download a file, please do so from your Purchases page or the product page. Download links are set to expire. You might get an error if you try to re-download a file from your browser's downloads page.
No comments yet!
Please login or register to write a comment.