Targus Tripod Quick Disconnect Plate Anida Technologies

File: Tripod Quick Disconnect Plate.stl
Name: QD_Plate
PLA Material: 9.53 grams ( 0.021 lbs)
Infill = 50%
Size: 34.56 mm (1.36") x 34.54 mm (1.36") x 10.8 mm (0.425")
Resolution: 0.20mm
Layers: 60 layers
Rafts: Yes
Supports: No
Print Time: 0 hr 45 min
Function:  I temporarily lost my quick disconnect plate for my old Targus tripod and found out that on Ebay they wanted as much for a replacement plate as I had paid for my tripod so I 3D printed one (careful, my old Targus seems much smaller than most ofthe quick disconnect plates on Ebay).  I had to cut off a #1/4-20 screw to go into the camera but it was pretty snug.  If I was going to use it a lot I would add a rubber washer between the mount and the camera.  Fortunately I found my original plate so this one is sitting in my bag ready to mount another DSLR or a Gopro to my tripod.  It should be printed 1:1.