8" caliper box Pratyeka
This is a box for an electronic Mitutoyo 8" caliper.
Made to be printed on a 200mm X200mm bed.
Print 2 of each part, they are symetrical.
I used a 0.050" rod for the hinge, bent at both end so it stays put.
Parts are press fit together, I used a hammer and pin, then a heat gun to gently warm the joints to relieve stress.
I use steel mesh and epoxy to reinforce the joints.
Printed on a FLSUN Prusa i3 clone at 0.2mm layers, in PLA.
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.