Universal torch clamp Ian Carrick
Printed using Flashforge Dreamer with Flashprint standard ABS settings with 15% infill, 80mm pre extrusion. Extruder temp 220, plate temp 105. All parts printed at the same time. No raft or brim but did use automatic supports, not really sure they were required. 3D print dimensionally accurate to 3D model however the swivel (largest piece) began to lift off the bed so has a slightly warped appearance. I've used common sized machine screws and nuts. Linkage and torch clamp uses M4 machine screw and M4 nut. The clamping blot is M6 bolt and nut. Also, with a 15% infill the clamp is quite weak and tends to 'open' as the clamping screw is tightened.
This work is licensed under the Redpah License.