Assembly Instructions; Print Settings: 0.8mm shell thickness (2 times my extruder diameter) 0.3mm layer height (For faster print, I lost no details) 20% infill Print: 1 X Center Gear 1 X Outside Gear 1 x turntable base 5 X Small Gear 5 X Foot Assembly: 1. Screw the 5 gears to the turntable base using small screws long enough to protrude from the button of the plate 2. Screw the feet onto the protruding threads of the screws from step 1 3. Place Outside gear into the turntable base 4. Rotate outside gear to remove any burrs. Keep spinning until it doesn't bind. 5. Place Center gear into the assembly. 6. Rotate outside gear to remove any burrs. Keep spinning until it doesn't bind. 7. You're done!